- Home
- Products
- Electronics
- Transmitters
- Futaba Accessories
- SBS/01RM Futaba Magnetic RPM sensor, Set
Share
SBS/01RM Futaba Magnetic RPM sensor, Set
In stock
Order now and it will be sent next Tuesday
Futaba Magnetic RPM sensor set SBS/01RM
The Futaba SBS-01RM magnetic RPM sensor makes it easy to read RPM on the transmitter. Simply connect the sensor to the S.BUS2 port of the telemetry-compatible receiver, and the bi-directional communication ensures that the data is sent directly to your Futaba T-FHSS or FASST transmitter.
Magnets mounting:
- Mount the first magnet with the active side to the sensor at the desired location of the rotating part, this can be done by gluing with 2-component glue or epoxy. The second magnet should be mounted in the opposite position to ensure balance. Make sure that the magnet with the non-active side points in the direction of the sensor, since the measurement will then be incorrect. This is easy to check in the manner described below.
Sensor mounting:
- The sensor must be mounted in a stable place, with or without the supplied holder. The distance between the magnet and sensor may be a maximum of 2 mm. After this mounting, connect the sensor to the module, and the module to an S.BUS2 port on the receiver.
Check sensor operation:
- When voltage is applied to the Sensor, the LED is on, no sensor signals are sent.
- The sensor only works when the active-side of the magnet is facing the sensor. You can check this by moving the magnet past the sensor.
- If the LED is blinking, this is the active side. Mark the active magnet side with a marker so that the assembly goes smoothly later.
Specifications:
- Displays: RPM/revolutions per minute
- Range: 360~100,000 RPM
- Cable length: 255 mm
- Voltage: 3.7~7.4 Volt
- Weight (with pick-up): 4.7 grams
Important:
- The SBS-01RM can only be used with telemetry receivers that have S.BUS 2 port(s). Refer to the manual supplied with your transmitter and/or receiver.
Write Your Own Review
Validate your login
Sign In
Create an Account