Instructions for using Photo Varnish;

Picture Varnish makes it possible to place any kind of image inside the body. It will be clearly visible on the outside.

Paint instructions:

• Prior to use, shake the can well for 2 to 5 minutes until you hear the steel mix ball mix evenly and bright rattle.
• Surface has to be clear of dust and grease to get the best result
• Make sure that the spray can has a temperature of about 20-25 degrees Celsius, and the setting temperature is at least 15 degrees Celsius!
• Spray the back of the image with several thin layers Photo Varnish, and let it dry for about 5-8 minutes.
• Now spray the front of the same image with several thin layers and place the wet image in the body, press it gently and let dry for 20-30 minutes.
• Now you can paint the body with all others colours you want, the picture remains clearly visible on the utside of the body
• Let one color dry for at least 30 minutes before spraying the others, and finally cover all with RC Car Colours White for optimum brightness.
• After use, keep the can upside down and spray for 2 seconds until the nozzle is clean. 

Important Notes!   

• Always work in a well ventilated area 
• Pressurized container. 
• Protect from sunlight and do not expose to temperatures exceeding 50 ° C. 
• Even after use, do not pierce or burn. 
• Keep away from sources of ignition and open flames - no smoking. 
• Do not spray into a naked flame or any incandescent material. 
• Keep out of reach of children.

NOTE! PRESSURED CANS CAN NOT BE SHIPPED OUTSIDE THE EU